Ametek Process 9000 Form Ametek Process Analyzer Application Form NameThis field is for validation purposes and should be left unchanged.Please fill in as much information as you canYour Name(Required) First Last Your Email Address(Required) Email Address Confirm Email Address Your Phone(Required)Company / Plant / Process / Licensor:Process Component to be analyzedcomponent:analyzer range: ____ to _____ Add Removeppm / % / by weight / by volume / otherProcess Component to be analyzedcomponent:analyzer range: ____ to _____ Add Removeppm / % / by weight / by volume / otherProcess Component to be analyzedcomponent:analyzer range: ____ to _____ Add Removeppm / % / by weight / by volume / otherConcentration ranges of all components in stream(list all known, even if in ppm range)Choose one By weight By volume Conc. range of all components in streamcomponent______ % to______% Add RemoveConc. range of all components in streamcomponent______ % to______% Add RemoveConc. range of all components in streamcomponent______ % to______% Add RemoveConc. range of all components in streamcomponent______ % to______% Add RemoveConc. range of all components in streamcomponent______ % to______% Add RemoveConc. range of all components in streamcomponent______ % to______% Add RemoveConc. range of all components in streamcomponent______ % to______% Add RemoveConc. range of all components in streamcomponent______ % to______% Add RemoveConc. range of all components in streamcomponent______ % to______% Add RemoveProcess conditions at sample tapProcess connection:Piping orientation for mounting of probe Vertical Horizontal TemperatureNormalMin:Max:Units Add RemovePressureNormalMin:Max:Units Add RemovePhase(s)(gas, liquid)Other data(viscosity, unusual surges, contaminants)If vapor phase, dew point Temp Pressure Sample boiling pointat atm pressureAre there likely to be any particulates, mists, etc., in the sample? If so, describe:Conditions at analyzer discharge point:Process connection:To atmosphere or waste stream at atmospheric pressure check if yes Return to process atPressureRangeUnitsat _____ temp Add RemoveVent/Scrubber (by customer):PressureRangeUnits: Add RemoveMaterials of construction which may be used in contact with sample:Metals:Plastics:Can you furnish spectrophotometric scans of your sample? Please email if available) Yes No Lab analysis method:Environment at probably analyzer site(control station assumed to be in protected area)Analyzer will be: Indoors Outdoors Temperature range: ________ to _________Average barometric pressure:Solar radiation temperature:Shelter to be provided by: Ametek Others Type (materials, rating, etc):Conditions analyzer will be exposed to(corrosive or explosive: excessive moisture, dust):Hazardous area electrical classificationAt analyzer, field unit location: General Purpose Hazardous if HazardousClassGroupDiv/ZoneT Class Add RemoveAt analyzer, control station location: General Purpose Hazardous if HazardousClassGroupDiv/ZoneT Class Add RemoveUtilities available: 115 V 60 Hz 115 V 50 Hz If Steam, Pressure?If Nitrogen, Pressure? 230 V 60 Hz 230 V 50 Hz If Instrument Air, Pressure?If Clear Water, Pressure? UPS Available Instrument Air, Pressure?Other, Please specify:Sample system to be supplied by AMETEK?If yes, specify distance from sample tap to probable analyzer site:Describe installations space limitations, if anyHeight, Width, DepthNumber of sample streams:Permissible zero fluid:If no, specify sample conditions available at analyzerInlet Pressure and TemperatureOutlet Pressure and TemperatureAnalyzer output desired and quantity 4 to 20mA Held signal required Alarms required Relays Other Type of relay contacts Ac Dc Third Choice Computation required for desired outputs(LB/MMBTU, etc)Sample lines:LengthLengthLength Add RemoveSample lines:LengthLengthLength Add Remove
